If you want to know how to inject steroids , the first thing you need to know is how to prepare for the injection. You know you need to stick it into the muscle tissue, and we’ll go into the specifics of that later on, but there’s more to it than that. There are eight specific steps you need to follow when injecting anabolic steroids, and while that may sound like a lot the whole process shouldn’t take but a minute. Failure to follow these eight remarkably simple steps can result in complications such as infections or simply very uncomfortable injections, and an unnecessarily sore injected area.
The original brand name of oxandrolone was Anavar, which was marketed in the United States and the Netherlands .   This product was eventually discontinued and replaced in the United States with a new product named Oxandrin, which is the sole remaining brand name for oxandrolone in the United States.   Oxandrolone has also been sold under the brand names Antitriol ( Spain ), Anatrophill ( France ), Lipidex ( Brazil ), Lonavar ( Argentina , Australia , Italy ), Protivar, and Vasorome ( Japan ) among others.     Additional brand names exist for products that are manufactured for the steroid black market. 
The ‘Two-Pin’ technique increases sanitation for multiple dose vial users. They draw with the first pin, and then shoot/inject into the body with a new one. This procedure prevents any residual contaminants that may have remained on the drawing pin from being transferred into the body via the injection site. It also makes injection less painful since the drawing needle is necessarily dulled during passage through the rubber stopper atop the vial. A dulled needle increases injection pain because it doesn’t pierce the body as cleanly as an unused one. The protocol below is followed by AAS users who draw from multiple dose vials, but steps 4 - 8 are routinely disregarded by those users who draw from ampoules (also called ampules) and sachets.